Ano DISPART jsem našel i ve ve Vistách, staci v prikazove radce napsat DISPART a enter a otevre se s nim nove okno, teď už jen postupovat podle toho návodu na:
http://www.tomshardware.co.uk/forum/248031-44-acer-laptop-recovery-problemsPodle nize uvedeného postupu se mi podařilo zviditelnit ten PQSERVICE
PLEASE DO NOT FORGET , PARTITION NUMBER, TYPE, VOLUME NUMBER, TYPE CAN BE DIFFERENT, WHEN CHANGING THIS NOTE THEM ALL...
Here's the step by step to succeed...
Press "win + r" to bring up the run window
Type: "cmd", to bring up the command window
Type: "diskpart", a new command window pops up with a "Diskpart >" prompt
Type: "rescan", a configuration check runs
Type: "list disk", a list of the availible disks appears
Type: "select disk 0", if your hidden partition resides on that disk of course
Type: "list partition", to find out with partition is your hidden one (probably about 10 gb and without name)
Type: "select partition 1", if that is your hidden partition
Type: "detail partition", here you will see the partition type, take a note of that so that you can reset it to the original if needed.
If your partition type = 27 you should enter id=07 in the step below, if type = 12 enter id=0B in the step below.
Type: "set id=07 override", where 07 is the number from the step above - to unhide your partition
Type: "select disk 0", to go back to the top of the disk again
Type: "list volume", you should be able to see the "pqservice" volume
Type: "select volume 0", if that is your pqservice partition
Type: "assign letter=f", where f should be your first free driveletter (listed in "list volume" command) remember the CD/DVD driveletter!!
When you have completed all the steps, the pqservice disk should autostart in windows (no reboot needed), if not press "win + e" to bring up explorer and find your new disk
All the contents are now yours for the taking!!
Close the command windows and you are done!!!
povedlo se, viz obrázek
rtmbr2.bin tam nemám, mám tam jen tyto dva:
rtmbrold.bin
rtmbr.bin
navíc nejsou ani v adresáři RYTOOLS, ale přímo v PQSERVICE
zkoušel jsem instalovat ten rtmbr.bin i rtmbrold.bin ale to nešlo
To jsem asi teď namydlenej.....a
po tom všem mě stejne čeká přeinstalace
Takže alespoň na závěr jsem uvedl PQSERVICE do původního stavu:
Press "win + r" to bring up the run window
Type: "cmd", to bring up the command window
Type: "diskpart", a new command window pops up with a "Diskpart >" prompt
Type: "rescan", a configuration check runs
Type: "select disk 0", if your hidden partition resided on that disk of course
Type: "select volume 0", if that is your pqservice partition
Type: "remove letter=f", where f is the letter you assigned to the volume
Type: "select disk 0", to go back to the top of the disk again
Type: "select partition 1", if that was your hidden partition
Type: "set id=27 override", where 27 is the number that you hopefully wrote down somewhere - to hide your partition again
And it should be hidden again!
[příloha smazaná administrátorem]
[příloha smazaná administrátorem]