Zobrazit příspěvky

Internet a sítě / Problem s modemom

« kdy: 22 Březen 2008, 10:49:13 »

Používam vigor 318 presiel som desiatky navodov na internete nemusite davat linky lebo vetsinu poznam.

Tak sa zda ze to este fungovalo na 6 ale uz nie na 7.10 takisto vetsina navodov je stara 2-3 roky. Dostavam tieto hlasky:

ifconfig

--------------------------
eth0 Link encap:Ethernet HWaddr 00:11:09:DB:7B:B9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:16

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:16 errors:0 dropped:0 overruns:0 frame:0
TX packets:16 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1184 (1.1 KB) TX bytes:1184 (1.1 KB)

nas0 Link encap:Ethernet HWaddr 00:50:7F:1C:3D:E3
inet6 addr: fe80::250:7fff:fe1c:3de3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:9 errors:0 dropped:0 overruns:0 frame:0
TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:418 (418.0 b) TX bytes:945 (945.0 b)
----------------------------------------------------------------
route

Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
----------------------------------------------------------------
iptables -L

Chain INPUT (policy ACCEPT)
target prot opt source destination

Chain FORWARD (policy ACCEPT)
target prot opt source destination

Chain OUTPUT (policy ACCEPT)
target prot opt source destination

--------------------------------------------------------
dhclient nas0:

ifconfig

Internet Systems Consortium DHCP Client V3.0.5
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

Listening on LPF/nas0/00:50:7f:1c:3d:e3
Sending on LPF/nas0/00:50:7f:1c:3d:e3
Sending on Socket/fallback
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 4
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 8
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 9
DHCPDISCOVER on nas0 to 255.255.255.255 port 67 interval 3
No DHCPOFFERS received.
No working leases in persistent database - sleeping.
-------------------------------------------------------------------------------------------
ifconfig:

eth0 Link encap:Ethernet HWaddr 00:11:09:DB:7B:B9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:16

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:80 errors:0 dropped:0 overruns:0 frame:0
TX packets:80 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:5968 (5.8 KB) TX bytes:5968 (5.8 KB)

nas0 Link encap:Ethernet HWaddr 00:50:7F:1C:3D:E3
inet6 addr: fe80::250:7fff:fe1c:3de3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:36 errors:0 dropped:0 overruns:0 frame:0
TX packets:59 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1672 (1.6 KB) TX bytes:7193 (7.0 KB)

nas0:avah Link encap:Ethernet HWaddr 00:50:7F:1C:3D:E3
inet addr:169.254.7.6 Bcast:169.254.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
--------------------------------------------------------------

Vie mi to niekto prelozit do jazyka smrtelnikov? Skusal som uz niekolko desiatok kombinaci a nic a na novy modem nemam a je mi trapne behat stale na xp koli kazdej linuxovej veci co potrebujem z netu :'(

dakujem za pomoc

Novinky:

Informace