Zdravím, mám problém pri vypaľovaní dvd. Skúšal som to v Brasero, K3B, aj v konzole cez cdrecord (skúšal som napáliť iso súbor). Vždy to skončí ešte pred tým ako sa začne zapisovať. Ubuntu je 11.10.
Výpis z cdrecord
cdrecord: No write mode specified.
cdrecord: Assuming -sao mode.
cdrecord: If your drive does not accept -sao, try -tao.
cdrecord: Future versions of cdrecord may have different drive dependent defaults.
Cdrecord-ProDVD-ProBD-Clone 3.01a06 (i686-pc-linux-gnu) Copyright (C) 1995-2011 Joerg Schilling
TOC Type: 1 = CD-ROM
scsidev: '1,0,0'
scsibus: 1 target: 0 lun: 0
Linux sg driver version: 3.5.34
Using libscg version 'schily-0.9'.
SCSI buffer size: 64512
atapi: 1
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identifikation : 'DVDRAM GSA-T20N '
Revision : 'WR02'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Current: DVD-R sequential recording
Profile: DVD-RAM
Profile: DVD-R sequential recording (current)
Profile: DVD-R/DL sequential recording
Profile: DVD-RW sequential recording
Profile: DVD-RW restricted overwrite
Profile: DVD+RW
Profile: DVD+R
Profile: DVD+R/DL
Profile: DVD-ROM
Profile: CD-R
Profile: CD-RW
Profile: CD-ROM
Profile: Removable Disk
Using generic SCSI-3/mmc-2 DVD-R/DVD-RW/DVD-RAM driver (mmc_dvd).
Driver flags : NO-CD DVD MMC-3 SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1114112 = 1088 KB
Drive pbuf size: 1966080 = 1920 KB
Drive DMA Speed: 13963 kB/s 79x CD 10x DVD 3x BD
FIFO size : 4194304 = 4096 KB
Track 01: data 2749 MB
Total size: 2749 MB = 1407794 sectors
Current Secsize: 2048
Total power on hours: 0
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 890702
Reducing transfer size from 64512 to 32768 bytes.
Starting to write CD/DVD/BD at speed 8 in real SAO mode for single session.
Last chance to quit, starting real write 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Starting new track at sector: 0
Track 01: 0 of 2749 MB written.cdrecord: Chyba vstupu/výstupu. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 10 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 32 4D 03 0C 0C 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x00 (write error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 18.959s timeout 200s
write track data: error after 0 bytes
cdrecord: A write error occured.
cdrecord: Please properly read the error message above.
Writing time: 24.008s
Average write speed 86,8x.
Fixating...
Fixating time: 0.003s
cdrecord: fifo had 128 puts and 1 gets.
cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
verzia cdrecord:
Cdrecord-ProDVD-ProBD-Clone 3.01a06 (i686-pc-linux-gnu) Copyright (C) 1995-2011 Joerg Schilling
V prípade, že bude treba ďalšie info, tak prosím napíšte aké...
Vopred ďakujem za akékoľvek rady...