Fórum Ubuntu CZ/SK
Ubuntu pro osobní počítače => Internet a sítě => Téma založeno: biggles81 24 Prosince 2008, 22:51:14
-
Ahoj,
rad bych si rozjel na svem notebooku wifi, jenze se mi to ne a nedari. Prosel jsem ruzne navody, ale zadny mi prilis nepomohl.
Mam Acer Aspire 1360 - Kubuntu
Nastavil jsem si wifi kartu, nicmene nemuzu najit zadne wifi site a ikdyz nastavim napevno wifi sit ke ktere se chci pripojit, tak bezuspesne.
Diky za kazdy tip, jak to rozjet
Polda
biggles@polda:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:off/any Nickname:"home"
Mode:Managed Frequency:2.437 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s
RTS thr=2347 B Fragment thr=2346 B
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
biggles@polda:~$ iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wlan0 No scan results
biggles@polda:~$ dmesg | grep wlan
[ 43.751111] wlan0: ethernet device 00:0e:9b:6f:6c:d7 using NDIS driver: neti2220, version: 0x2000a, NDIS version: 0x501, vendor: 'INPROCOMM IPN2220 Wireless LAN Adapter', 17FE:2220.5.conf
[ 43.751133] wlan0: encryption modes supported: WEP; TKIP with WPA; AES/CCMP with WPA
[ 115.067889] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 1318.419826] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 1416.302804] ADDRCONF(NETDEV_UP): wlan0: link is not ready
-
ndiswrapper -l
ndiswrapper -m
pokud detekuje zařízení tak to rozhraní zkuste nahodit ručně
ip link set wlan0 up
edit:// a případně mrkněte sem: http://jablkojablko.webz.cz/stranky_o_linuxu/sit_v_linuxu.html
-
Diky za tip, bohuzel se opet vse tvari, ze funguje, jen to proste nenajde zadnou sit :(. Ve windowsech ji najdu bez problemu.Budu vdecny za kazdou radu, te problematice moc nerozumim, takze to klidne muze byt nejaka uplne zakladni neznalost a kravina.
biggles@polda:~$ sudo ndiswrapper -l
neti2220 : driver installed
device (17FE:2220) present
biggles@polda:~$ sudo ndiswrapper -m
module configuration already contains alias directive
Rucni nahozeni site se nezda ze by melo nejaky ucinek. iwlist scan stale pise no scan result a vypis iwconfigu zustal take stejny
Jeste prihazuju par dalsich vypisu
biggles@polda:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:0a:e4:5f:8b:2a
inet addr:10.0.0.4 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: fe80::20a:e4ff:fe5f:8b2a/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3912 errors:0 dropped:0 overruns:0 frame:0
TX packets:3008 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4549260 (4.3 MB) TX bytes:524844 (512.5 KB)
Interrupt:20 Base address:0x6800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 00:0e:9b:6f:6c:d7
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:19 Memory:c0005000-c0005800
biggles@polda:~$ dmesg | grep ndiswrapper
[ 52.621746] ndiswrapper version 1.52 loaded (smp=yes, preempt=no)
[ 52.725121] ndiswrapper: driver neti2220 (LanExpress,03/29/2004,2.10.03.2004) loaded
[ 52.757633] ndiswrapper: using IRQ 19
[ 52.967704] usbcore: registered new interface driver ndiswrapper
-
mrkněte sem: http://forum.kubuntu.sk/viewtopic.php?pid=18442#p18442
třeba to pomůže, jen namísto
kate
použijte
nano
-
Bohuzel, jedine co je v tom odkazu noveho je odstraneni nejakych modulu a ja tyto moduly vubec nemam zavedeny (podle lsmod a /etc/modules). Uz se pomalu smiruju s tim, ze se bez wifi budu muset obejit :'(
Polda
-
iwlist wlan0 scan Tak to má byť správne.
Pokial som vyrozumel, tak wifi ide cez NDisWrapper, a ten asi potrebuje
nejaký príkaz cez sudo, ktorým sa tá karta vobec ZAPNE.
Totiž že sa prezentuje driver aj karta nemusí ešte znamenať , že je wifi zapnutá.
-
Tu máš link na tvoju IPN2220 WiFi:
http://ubuntuforums.org/showthread.php?t=179270&highlight=InProComm+IPN2220+WiFi+HOW-TO%253Cbr%2520/%253Ethis%2520work (http://ubuntuforums.org/showthread.php?t=179270&highlight=InProComm+IPN2220+WiFi+HOW-TO%253Cbr%2520/%253Ethis%2520work)