Fórum Ubuntu CZ/SK
Ostatní => Archiv => Téma založeno: openmajlo 09 Listopadu 2006, 10:32:33
-
potřebuju pomoci ohledně vypalování. používám gnome, ale gnomebaker nebyl schopnej nic vypálit ( z jeho vypisu nejsem moc moudrej) tak jsem si nainstaloval k3b (+závislosti) a vypalování probíhalo úspěšně. je to asi měsíc. teď zkouším vypálit iso obraz cd a vždy to skončí chybou - není možné fixovat disk, došlo k chybě zápisu. přidávám výpis:
System
-----------------------
K3b Version: 0.12.17
KDE Version: 3.5.2
QT Version: 3.3.6
Kernel: 2.6.15-27-386
Devices
-----------------------
LITE-ON COMBO SOHC-5232K NK02 (/dev/hdc, ) at /media/cdrom0 [CD-R; CD-RW; CD-ROM; DVD-ROM] [DVD-ROM; CD-ROM; CD-R; CD-RW] [SAO; TAO; RAW; SAO/R96P; SAO/R96R; RAW/R16; RAW/R96P; RAW/R96R]
Used versions
-----------------------
cdrecord: 2.1.1a01
cdrecord
-----------------------
/usr/bin/cdrecord: Warning: Running on Linux-2.6.15-27-386
/usr/bin/cdrecord: There are unsettled issues with Linux-2.5 and newer.
/usr/bin/cdrecord: If you have unexpected problems, please try Linux-2.4 or Solaris.
scsidev: '/dev/hdc'
devname: '/dev/hdc'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
/usr/bin/cdrecord: Warning: using inofficial version of libscg (debian-0.8debian2 '@(#)scsitransp.c 1.91 04/06/17 Copyright 1988,1995,2000-2004 J. Schilling').
SCSI buffer size: 64512
Cdrecord-Clone 2.01.01a01 (i686-pc-linux-gnu) Copyright (C) 1995-2004 Joerg Schilling
NOTE: this version of cdrecord is an inofficial (modified) release of cdrecord
and thus may have bugs that are not present in the original version.
Please send bug reports and support requests to .
The original author should not be bothered with problems of this version.
TOC Type: 1 = CD-ROM
Using libscg version 'debian-0.8debian2'.
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'LITE-ON '
Identifikation : 'COMBO SOHC-5232K'
Revision : 'NK02'
Device seems to be: Generic mmc2 DVD-ROM.
Current: 0x0009
Profile: 0x0010
Profile: 0x000A
Profile: 0x0009 (current)
Profile: 0x0008
Profile: 0x0002
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE FORCESPEED
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1422080 = 1388 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 698 MB
Total size: 802 MB (79:27.53) = 357565 sectors
Lout start: 802 MB (79:29/40) = 357565 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type B, low Beta category (B-) (4)
ATIP start of lead in: -11933 (97:22/67)
ATIP start of lead out: 359849 (79:59/74)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 43
Manufacturer: Acer Media Technology, Inc.
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 2284
Forcespeed is OFF.
Starting to write CD/DVD at speed 52 in real SAO mode for single session.
Last chance to quit, starting real write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Turning BURN-Free on
Performing OPC...
Sending CUE sheet...
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 0 of 698 MB written.
/usr/bin/cdrecord: Success. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 01 55 00 00 1F 00
status: 0x4 (CONDITION MET/GOOD)
resid: 63488
cmd finished after 205.063s timeout 200s
/usr/bin/cdrecord: A write error occured.
/usr/bin/cdrecord: Please properly read the error message above.
/usr/bin/cdrecord: Success. test unit ready: scsi sendcmd: no error
CDB: 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes:
Sense Key: 0xFFFFFFFF [], Segment 0
Sense Code: 0x00 Qual 0x00 (no additional sense information) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.000s timeout 200s
write track data: error after 698368 bytes
Writing time: 220.565s
Average write speed 22.7x.
Fixating...
Fixating time: 0.002s
BURN-Free was never needed.
/usr/bin/cdrecord: fifo had 75 puts and 12 gets.
/usr/bin/cdrecord: fifo was 0 times empty and 3 times full, min fill was 85%.
cdrecord command:
-----------------------
/usr/bin/cdrecord.mmap -v gracetime=2 dev=/dev/hdc speed=52 -dao driveropts=burnfree -eject -data /home/milos/Desktop/ubuntu-6.10-desktop-i386.iso
nějaké rady ??? předem díky.
p.s. zkoušel jsem k3b spouštět jako root a dopadlo to stejně (respektive stejnej vysledek, vypis mozna vypadal jinak)
-
jo a teď jsem zkusil vypalit jen tak nějakej malej soubor a proběhlo to bez problémů. tak co se mu sakra nelíbí na iso obrazu ???
-
pokud vypalujes z FAT32 disku tak to dela bordel