USB AVR programátor AVR-Doper

[mirek]

Zdravim,
podle navodu na http://www.obdev.at/products/avrusb/avrdoper.html jsem si postavil USB programator pro Atmely. Pomoci jednoducheho parallelniho programatoru jsem naprogramoval procesor ktery programator ridi (ATmega8) a nastavil spravne fuse bity. Vse podle navodu. Bohuzel po zapojeni mi dmesg | grep usb vypise:

Kód: [Vybrat]

[17194402.064000] usb 1-3: new low speed USB device using ohci_hcd and address 10
[17194402.264000] usb 1-3: device descriptor read/all, error 0
[17194402.444000] usb 1-3: new low speed USB device using ohci_hcd and address 11
[17194402.624000] usb 1-3: device descriptor read/64, error -71
[17194402.908000] usb 1-3: device descriptor read/64, error -71
[17194403.188000] usb 1-3: new low speed USB device using ohci_hcd and address 12
[17194403.208000] usb 1-3: device descriptor read/8, error -110
[17194403.328000] usb 1-3: device descriptor read/8, error -110
[17194403.608000] usb 1-3: new low speed USB device using ohci_hcd and address 13
[17194403.628000] usb 1-3: device descriptor read/8, error -110
[17194403.748000] usb 1-3: device descriptor read/8, error -110Kdyz jsem zkousel podle navodu prikaz avrdude -c stk500v2 -P avrdoper -p atmega8 tak to vypsalo:

Kód: [Vybrat]

avrdude: avrdoper_open(): Device not found.Coz me vzhledem k predchozim radkum vubec neprekvapilo ...

Bohuzel vubec netusim proc to nefunguje, hraji si s tim uz pres ctrnact dni a bez uspechu. Zapojeni by melo byt vporadku, mnohokrat jsem jej prochazel.

Setkal jste se nekdo s necim podobnym ? Strejda google mi taky moc neporadil

Budu vdecny za jakykoliv tip . Diky Mira