Našiel som nasledovné:
pm cap regs version (7)
power management capabilities register version 7
some pci device in your computer uses version 7 which apparently is not supported by the kernel as of yet.
You can use sudo lspci -v and look to see which pci device uses version 7.
In my case it was the LAN card. So I went into the BIOS and disabled it and did not get a message.
So there is no danger to your system. It just cannot fully manage all the power options available to one of your pci devices. Probably the NIC. Its just too bad I still have to see that dang message every time.
http://ubuntuforums.org/archive/index.php/t-977074.htmlAk som to správne pochopil problém nájdem po príkaze
lspci -v a v BIOSE vypnem sieťovú kartu.
Problém je u mňa asi rovnaký:
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)
Subsystem: Toshiba America Info Systems Device ff66
Flags: bus master, fast devsel, latency 0, IRQ 220
I/O ports at 2000 [size=256]
Memory at d0410000 (64-bit, prefetchable) [size=4K]
Memory at d0400000 (64-bit, prefetchable) [size=64K]
Capabilities: [40] Power Management version 7
Capabilities: [50] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable+
Capabilities: [70] Express Endpoint, MSI 01
Capabilities: [ac] MSI-X: Enable- Mask- TabSize=2
Capabilities: [cc] Vital Product Data <?>
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [140] Virtual Channel <?>
Capabilities: [160] Device Serial Number 00-00-ff-ff-00-00-00-09
Kernel driver in use: r8169
Kernel modules: r8169
Je aj iné riešenie ?? Zatiaľ som vypol Lan v Biose. Prejavilo sa to zaujímavo, chybová hláška zmizla a pravdepodobne sa odstránil aj problém s chladením o ktorom som nevedel. Zdalo sa mi síce čudné, že chladenie sa zapínalo na maximum až pri vysokej teplote keď cez chladenie sálalo teplo ako z taviacej pece. Teraz si chladenie tichučko pradie priebežne a teplota je nízka.
Máte podobné skúsenosti s Toshibou?