USB Sitovka Wiretek USB 1.1

[DB]

Hola,
predem se omlouvam, za dalsi "lami" dotaz. K starsimu notebooku (Compaq Armada 1700) s Xubuntu jsem si koupil usb sitovku, propojil vse blika,sitove pripojeni eth0 je aktivni, jen to proste nejede.
byl k tomu driver rtl8150, ale kolega me tvrdil, ze jsem lama, ze ten je uz automaticky integrovanej v Xubuntu. tak protoze opravdu lama jsem a predpokladam, ze to bude jednoducha zalezitost na kterou ja neumim prijit bych chtel poprosit o radu. Moc diky a sorry.

[LS]

Bohuzel jste zapomnel napsat presny typ toho sitoveho zarizeni.

[DB]

pardon je to Wiretek usb 1.1 TO fast ethernet converter

kdyby to necemu pomohlo tady je manual instalace driveru pro Linux (proc jsem to jeste nevyzkousel ? Ale vyzkousel, ale protoze jsem linuxovy expert, tak to hazelo porad neplatny prikaz apod. :

The procedure to activate rtl8150 on linux is as follows:

  step 1: compile:
      gcc -DMODULE -D__KERNEL__ -c rtl8150.c -I%DIR%/include
      note: %DIR% is the directory of the kernel source code which is accompanied with
            the current kernel of your system. Normally it is located in /usr/src/linux.

  step 2: insert the driver as module:
           insmod rtl8150.o       
           (run 'lsmod' to see if the module is inserted)

  step 3: bind your card to an IP address:

           /sbin/ifconfig eth0 ${IPADDR} netmask ${NETMASK} broadcast ${BROADCAST}
           (run 'netstat -i' to see if there is a interface 'eth0')

  step 4: add your card to IP routing table and add gateway:
      /sbin/route add default gw ${GATEWAY} dev eth0


*make sure that your kernel is version 2.4.0 above. Otherwise, you have to
   upgrade your kernel.

diky