Proč mi Kubuntu nerozpozná HDD?

[webhope]

Mám problém, který mě trápí. Koupil jsem si disk SATA 500G a Linux při bootu nepozná že tam ten disk je. Očekával bych že v /dev/ uvidím oddíly sdb. Vidím pouze disk 160GB jako sda a jeho oddíly.

zkrácený výpis z dmesg

Kód: [Vybrat]

[    1.815174] ata_piix 0000:00:1f.1: version 2.12
[    1.815197] ata_piix 0000:00:1f.1: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[    1.815262] ata_piix 0000:00:1f.1: setting latency timer to 64
[    1.815382] scsi0 : ata_piix
[    1.815506] scsi1 : ata_piix
[    1.816653] ata1: PATA max UDMA/100 cmd 0x1f0 ctl 0x3f6 bmdma 0xf000 irq 14
[    1.816657] ata2: PATA max UDMA/100 cmd 0x170 ctl 0x376 bmdma 0xf008 irq 15
[    2.145638] ata2.00: ATA-6: WDC WD1600JB-00GVA0, 08.02D08, max UDMA/100
[    2.145643] ata2.00: 312581808 sectors, multi 16: LBA48
[    2.145700] ata2.01: ATAPI: HL-DT-ST DVDRAM GSA-4163B, A100, max UDMA/33
[    2.161596] ata2.00: configured for UDMA/100
[    2.176269] ata2.01: configured for UDMA/33
[    2.178700] scsi 1:0:0:0: Direct-Access     ATA      WDC WD1600JB-00G 08.0 PQ: 0 ANSI: 5
[    2.178837] sd 1:0:0:0: [sda] 312581808 512-byte hardware sectors: (160 GB/149 GiB)
[    2.178864] sd 1:0:0:0: [sda] Write Protect is off
[    2.178868] sd 1:0:0:0: [sda] Mode Sense: 00 3a 00 00
[    2.178909] sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[    2.178997] sd 1:0:0:0: [sda] 312581808 512-byte hardware sectors: (160 GB/149 GiB)
[    2.179020] sd 1:0:0:0: [sda] Write Protect is off
[    2.179024] sd 1:0:0:0: [sda] Mode Sense: 00 3a 00 00
[    2.179064] sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[    2.179069]  sda: sda1 sda2 sda3 sda4 < sda5 sda6 sda7 sda8 sda9 >
[    2.259817] sd 1:0:0:0: [sda] Attached SCSI disk
[    2.259886] sd 1:0:0:0: Attached scsi generic sg0 type 0
[    2.263649] scsi 1:0:1:0: CD-ROM            HL-DT-ST DVDRAM GSA-4163B A100 PQ: 0 ANSI: 5
[    2.275970] sr0: scsi3-mmc drive: 40x/40x writer dvd-ram cd/rw xa/form2 cdda tray
[    2.275975] Uniform CD-ROM driver Revision: 3.20
[    2.276106] sr 1:0:1:0: Attached scsi CD-ROM sr0
[    2.276164] sr 1:0:1:0: Attached scsi generic sg1 type 5
[    2.276193] ata_piix 0000:00:1f.2: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[    2.276199] ata_piix 0000:00:1f.2: MAP [ P0 -- P1 -- ]
[    2.276257] ata_piix 0000:00:1f.2: setting latency timer to 64
[    2.276336] scsi2 : ata_piix
[    2.276412] scsi3 : ata_piix


[arrange]

Snad nebude tak zle. Pošli nám víc informací a třeba s tím něco uděláme.