Skystar 2 a ovladač

[KEnik]

Zdravím,
karta funguje ale ovládání se mi nedaří.
irw
ani
sudo irrecord -d /dev/lirc0 TTS35AI
nic nezaznamena


návod je zde ale stahovat balicky se mi nechce podle me je to zbytecne lirc uz mam

Kód: [Vybrat]

./configure --with-kerneldir=/usr/src/linux-headers-$(uname -r) --with-driver=serial
cp drivers/lirc_serial/lirc_serial.ko drivers/lirc_dev/lirc_dev.ko /lib/modules/$(uname -r)/misc/
depmod $(uname -r)

http://www.abclinuxu.cz/hardware/pridavne-karty/televizni-karty/dvb-t/pci/technisat-airstar-2

u dalšího bodu se ale zaseknu

Kód: [Vybrat]

modprobe lirc_serial
WARNING: All config files need .conf: /etc/modprobe.d/alsa-base.conf.backup, it will be ignored in a future release.
WARNING: All config files need .conf: /etc/modprobe.d/alsa-base.conf-novy, it will be ignored in a future release.

nastavení

 

Kód: [Vybrat]

dmesg|grep serial
[    0.992985] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
[   11.755394] lirc_serial: auto-detected active low receiver
[   11.755449] lirc_serial $Revision: 5.104 $ registered


Kód: [Vybrat]

# /etc/lirc/hardware.conf
#
#Chosen Remote Control
REMOTE="Technisat MediaFocus I"
REMOTE_MODULES=""
REMOTE_DRIVER=""
REMOTE_DEVICE=""
REMOTE_SOCKET=""
REMOTE_LIRCD_CONF="technisat/lircd.conf.mediafocusI"
REMOTE_LIRCD_ARGS=""

#Chosen IR Transmitter
TRANSMITTER="Serial Port (UART) : Sky Satellite Receiver"
TRANSMITTER_MODULES="lirc_dev lirc_serial"
TRANSMITTER_DRIVER=""
TRANSMITTER_DEVICE="/dev/lirc0"
TRANSMITTER_SOCKET=""
TRANSMITTER_LIRCD_CONF="sky/general.conf"
TRANSMITTER_LIRCD_ARGS=""

#Enable lircd
START_LIRCD="true"

#Don't start lircmd even if there seems to be a good config file
#START_LIRCMD="false"

#Try to load appropriate kernel modules
LOAD_MODULES="true"

# Default configuration files for your hardware if any
LIRCMD_CONF=""

#Forcing noninteractive reconfiguration
#If lirc is to be reconfigured by an external application
#that doesn't have a debconf frontend available, the noninteractive
#frontend can be invoked and set to parse REMOTE and TRANSMITTER
#It will then populate all other variables without any user input
#If you would like to configure lirc via standard methods, be sure
#to leave this set to "false"
FORCE_NONINTERACTIVE_RECONFIGURATION="false"
START_LIRCMD=""
predem diky