ahoj mam problem z hdd . nasli se tam chybne sectory potrebuji pro svou praci tam dostat windowsi ale ani lnux a ani windows nejde kvul tomu nainstalovat novej hardisk si kupovat zatim nebudu protoze ceni hardisku sou astronomicke na notebook
tady vipis z terminalu
== START OF INFORMATION SECTION ===
Model Family: Western Digital Scorpio Blue Serial ATA
Device Model: WDC WD3200BEVT-22ZCT0
Serial Number: WD-WX30E69E1040
LU WWN Device Id: 5 0014ee 2032251cc
Firmware Version: 11.01A11
User Capacity: 320,072,933,376 bytes [320 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Sat Mar 24 18:33:21 2012 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 73) The previous self-test completed having
a test element that failed and the test
element that failed is not known.
Total time to complete Offline
data collection: ( 9600) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 113) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SCT capabilities: (0x303f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x002f 177 177 051 Pre-fail Always - 296302
3 Spin_Up_Time 0x0027 187 184 021 Pre-fail Always - 1641
4 Start_Stop_Count 0x0032 094 094 000 Old_age Always - 6834
5 Reallocated_Sector_Ct 0x0033 029 029 140 Pre-fail Always FAILING_NOW 1365
7 Seek_Error_Rate 0x002e 001 001 000 Old_age Always - 150197
9 Power_On_Hours 0x0032 093 093 000 Old_age Always - 5534
10 Spin_Retry_Count 0x0033 100 099 051 Pre-fail Always - 0
11 Calibration_Retry_Count 0x0032 100 100 000 Old_age Always - 0
12 Power_Cycle_Count 0x0032 096 096 000 Old_age Always - 4014
192 Power-Off_Retract_Count 0x0032 199 199 000 Old_age Always - 1014
193 Load_Cycle_Count 0x0032 192 192 000 Old_age Always - 26013
194 Temperature_Celsius 0x0022 087 087 000 Old_age Always - 60
196 Reallocated_Event_Count 0x0032 001 001 000 Old_age Always - 1365
197 Current_Pending_Sector 0x0032 200 199 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0009 100 253 051 Pre-fail Offline - 0
SMART Error Log Version: 1
Warning: ATA error count 50687 inconsistent with error log pointer 5
ATA Error Count: 50687 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 50687 occurred at disk power-on lifetime: 5488 hours (228 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
01 51 01 51 12 63 e0 Error: AMNF at LBA = 0x00631251 = 6492753
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
24 ff 01 51 12 63 0f 00 00:33:52.808 READ SECTOR(S) EXT
25 ff 01 51 12 63 0f 00 00:33:49.610 READ DMA EXT
35 ff 01 50 12 63 0f 00 00:33:49.050 WRITE DMA EXT
25 ff 01 50 12 63 0f 00 00:33:49.049 READ DMA EXT
24 ff 01 51 12 63 0f 00 00:33:46.120 READ SECTOR(S) EXT
Error 50686 occurred at disk power-on lifetime: 5488 hours (228 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 51 12 63 e0 Error: UNC 1 sectors at LBA = 0x00631251 = 6492753
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 ff 01 51 12 63 0f 00 00:33:49.610 READ DMA EXT
35 ff 01 50 12 63 0f 00 00:33:49.050 WRITE DMA EXT
25 ff 01 50 12 63 0f 00 00:33:49.049 READ DMA EXT
24 ff 01 51 12 63 0f 00 00:33:46.120 READ SECTOR(S) EXT
25 ff 01 51 12 63 0f 00 00:33:42.485 READ DMA EXT
Error 50685 occurred at disk power-on lifetime: 5488 hours (228 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
01 51 01 51 12 63 e0 Error: AMNF at LBA = 0x00631251 = 6492753
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
24 ff 01 51 12 63 0f 00 00:33:46.120 READ SECTOR(S) EXT
25 ff 01 51 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 50 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 4f 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 4e 12 63 0f 00 00:33:42.484 READ DMA EXT
Error 50684 occurred at disk power-on lifetime: 5488 hours (228 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
01 51 01 51 12 63 e0 Error: AMNF 1 sectors at LBA = 0x00631251 = 6492753
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 ff 01 51 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 50 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 4f 12 63 0f 00 00:33:42.485 READ DMA EXT
25 ff 01 4e 12 63 0f 00 00:33:42.484 READ DMA EXT
25 ff 01 4d 12 63 0f 00 00:33:42.484 READ DMA EXT
Error 50683 occurred at disk power-on lifetime: 5488 hours (228 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 7f d4 11 63 e0 Error: UNC at LBA = 0x006311d4 = 6492628
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
29 ff 7f d4 11 63 0f 00 00:33:39.159 READ MULTIPLE EXT
25 ff 7f d4 11 63 0f 00 00:33:36.199 READ DMA EXT
25 ff 7f 55 11 63 0f 00 00:33:36.198 READ DMA EXT
25 ff 7f d6 10 63 0f 00 00:33:36.197 READ DMA EXT
25 ff 7f 57 10 63 0f 00 00:33:36.196 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed: unknown failure 90% 5533 -
# 2 Conveyance offline Completed: unknown failure 90% 5533 -
# 3 Conveyance offline Completed: unknown failure 90% 5473 -
# 4 Short offline Completed without error 00% 1 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
zkousel sem hdd regenerator ale u 50-60 procent se to vipne a chce to ze v boot mam nastavit jinou formu IDE myslim misto asci nastavil sem to a stejne to vyskocilo jestli nejde zjistit na jake casti disku je chyba a zablokovat ji nebo tka nejak dekuji moc
Téma: Hdd-prosim Pomoc (Přečteno 1876 krát)
